netstat filezilla windows not releasing connections

The names that correspond to the IP address and the port are shown unless the -n parameter is specified. The IP address and port number of the remote computer to which the socket is connected. If the port is not yet established, the port number is shown as an asterisk (*).

The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is specified. The IP address of the local computer and the port number being used. The name of the protocol (IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, or UDPv6). The following table shows the items for which netstat provides statistics.Used without parameters, netstat displays Help text.Parameters used with this command can be prefixed with a hyphen (-) or a slash (/).If this parameter is omitted, netstat prints the selected information only once. Redisplays the selected information every Interval seconds. This is equivalent to the route print command. The -p parameter can be used to specify a subset of the default.ĭisplays the contents of the IP routing table. By default, statistics are shown for the IP, IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, and UDPv6 protocols. In this case, the Protocol can be IP, IPv6, ICMP, ICMPv6, TCP, TCPv6, UDP, or UDPv6.ĭisplays statistics by protocol. Shows connections for the protocol specified by Proto. netstat ĭisplays Ethernet statistics, such as the number of bytes and packets sent and received.ĭisplays active TCP connections, however, addresses and port numbers are expressed numerically and no attempt is made to determine names.

Used without parameters, netstat displays Help text. The netstat utility displays active TCP connections, ports on which the computer is listening, Ethernet statistics, the IP routing table, IPv4 statistics (for the IP, ICMP, TCP, and UDP protocols), and IPv6 statistics (for the IPv6, ICMPv6, TCP over IPv6, and UDP over IPv6 protocols).

Netstat filezilla windows not releasing connections